Fjo injector driver box

-FJO injector driver box -Walboro lph HP fuel pump (wired to 14V alternator output with 10 gauge wire) -#8an feed line -Aeromotive fuel pressure regulator. The FJO Low Impedance Injector Driver is built for the racing environment to withstand heat, vibration, dirt and water. It is designed to operate over the temperature range from to + degrees Fahrenheit ( to +85 degrees Celsius). 4 independent injector channels with input preloaded to ohms.  · On the FJO site there is aLow Impedance Injector Driver FJO Racing Electronics is very pleased to offer a stand-alone low impedance injector driver. This product allows the use of low impedance injectors with ECUs designed for high impedance injectors only. The Low Impedance Injector Driver.

No prob - just remember the FJO box is probably the better to get and they're ~$ per 4 channel, so two of those + injectors figure $ - $ as a package. But, there are a lot of Lo Z injectors available to choose from and tons of people use them for a long long long time with good results. The basic EFI box, just the controller box is $ for a 4 injector driver box. The 8 injector driver box is $ Here is the specs on the system with 8 injector drivers. Injector (Front Primary): FD pin 4W. Injector (Front Secondary): FD pin 4X. Injector (Rear Primary): FD pin 4Y. Injector (Rear Secondary): FD Pin 4Z. Knock Sensor: FD pin 3M. RPM switch: FD pin 4R, switched ground, controllable by sequential turbo transition settings in Datalogit Settings 1 screen.

Battery connections to fuse holder / relay 12"; Relay to driver box 28"; Driver box to injector harness connections 40"; Injector harness; Cylinder A/B 13 de abr. de 3rd Generation Specific () - FJO Injector Driver Installation - I am trying to You bridge the box into your fuel injector wiring so that it's. AEM EMS - Peak Hold Injector Driver recommendations. they don't come out of the box with the ability to run low impedence injectors.